Kenwood KRC 17 G Service Manual

Page 5

KRC-17G/YA/YG, 194A/G/YA/YG, 266LA/LG/RG
KRC-27YA/YG, 2904YA/YG, 294A/G/YA/YG

ADJUSTM ENT

RECEIVER ALIGNMENT

No ITEM INPUT SETTINGS SETTINGS POINTS

ALIGN FOR

FM SECTION

98.1 MHz TEST MODE: ON Preset "1" key, grgiewgiengfifsse "1" key' press and Old preset 6 key
1 SD 0 dev FM and

a5dEtu(ANT input) 98.1 MHz preset "6" key ,ng 33. I: $336M

AM SECTION

While holding preset "1" key, press and hold preset "6" key
for a few seconds

"ADJ OK" is good.

"ADJ NG" is not good.

990 kHz TEST MODE: ON Preset "1" key,
(1 ) SD 0% mod AM and
35dBu(ANT input) 990 kHz preset "6" key

CASSETTE DECK SECTION

1) During FWD transport adjust F and F ' so that line A of 27
LINE TAPE passes through the center of the head shield
plate (core center area)

2) During FlVS transport adjust R and R ' so that line B of 2*
HEAD . LINE TAPE passes through the center of the head shield

[1] HEIGHT SCCE1659 TAPE PLAY Head Height Screw plate (core center area)

3) After the alignment above, reverse the transport direction
and check the FWD alignment again If it is deviated, perform
alignment againt

(Tape used : SCCE1659,manufactured by AEBEX)

Connect an AC
voltmeter and

2 HEAD TCCE153 oscilloscope to AEifnatfth Adjust the azimuth for each L ch/Fl ch or FWD/RVS
I I AZIMUTH 10kHz SP Outputs. 8 becomes maximum.
crew
TAPE PLAY

TEST MODE : ON While holding the "FM" key and preset "6" key, reset the unit
TEST MODE : OFF Reset the unit.

TAPE SPEED
(2-LINE TAPE)
B
HEIGHT ' ®' .. . HEIGHT
(FWD) ®\i/ RVS
A' 6&9 I I
(FWD) [e
e
(3%?
B _
I HEIGHT/AZIMUTH ®/ ® " 'HEIGHT/AZIMUTH
(FWD) (RVS)
A