Kenwood KR 4070 Owners Manual

Page 2

INTRODUCTION

The purpose of this manual is to acquaint
you with the operating features of your new
receiver. You will notice that in every detail of
planning. engineering. styling, operating con-
venience, and adaptability. we have sought to an-
ticipate your needs and desires.

We suggest that you read this manual
carefully. Knowing how to set up your receiver,
to the best advantage, will enhance your listening
pleasure right from the start. You will also
become aware of the ease with which you can
adjust your receiver to meet your special re-
quirements.

SERIAL NUMBER

Record your SERIAL NUMBER on the
spaces designated on the warranty card. You will
find the serial number on the back of the unit.

AFTER UNPACKING

After unpacking. we recommend you inspect
and examine the unit for any possible shipping
damage. If your unit is damaged or fails to
operate, notify your dealer immediately. If your
unit was shipped to you directly, notify the
shipping company without delay. Only the
consignee (the person or company receiving the
unit) can file a claim against the carrier for
shipping damage.

We recommend you retain the original
carton and packing materials to prevent any
damage should you transport or ship your unit in
the future.

, PRECAUTIONS ON INSTALLATION

a) Avoid locations subject to direct sunlight.

b) Avoid high or low temperature extremes.

c) Keep the unit away from heat radiating
source and magnetism generating source.

d) Choose locations with as little vibration and
dust as possible.

WARNING:

TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOIS-
TURE.

2 -40 701 K)

' IMPORTANT!

1. Units shipped to U.S.A. and Canada are
designed to operate on 120 volts AC only
and are not equipped with an AC Voltage
Selector Switch. Therefore. the following
description on such a switch should be
disregarded. =

2. Units shipped to all other countries are
eQuipped with an ACVoltage Selector
Switch on the rear panel. The following
description \on this switch. AC Voltage
Selection", should be carefully read.

AC VOLTAGE SELECTION

This unit operates on 120 volts, 220 volts or
240 volts AC. The AC Voltage Selector Switch is
set to the voltage generally available in the
country where the unit is shipped. It is important
to make sure, before connecting the power cord to
your AC outlet, whether the setting position of this
switch corresponds to your voltage. If not, it must
be changed to the prOper setting in accordance
with the direction below.

NOTE:
Our warranty does not cover damage caused by excessive
line voltage due to improper setting of the AC Voltage
Selector Switch.

Stopper plate
Screw

® Lever @ (3
AC 120v~ C] C]
Position
AC 220V~
Fosttron D
C] AC 240v~
Posmon
© © ©

1 Remove screw and stopper plate
2 Slide lever to your line voltage.
3 Lack lever wrth stopper plate and screw.

AC VOLTAGE SELECTOR SWITCH