Kenwood KDCC 661 Owners Manual

Page 1

' KENWOOD

KDC-C711
KDC-C661

COMPACT DISC AUTO CHANGER

INSTRUCTION MANUAL

CHANGEUR AUTOMATIQUE DE DISQUES COMPACTS

MODE DEMPLOI

CAMBIADOR AUTOMATICO DE DISCOS COMPACTOS

MANUAL DE INSTRUCCIONES

CHANGER AUTOMATICO DE CDS

MANUAL DE INSTRucoEs

KENWOOD CORPORATION

@COMPACT
DIGIQ§J[DIBO

Take the time to read through this instruction manual.
Familiarity with installation and operation procedures will help
you obtain the best performance from your new compact disc
auto changer.

For your records

Record the serial number, found on the back of the unit, in the spaces
designated on the warranty card, and in the space provided below.
Refer to the model and serial numbers whenever you call upon your
KENWOOD dealer for information or service on the product.

Model KDC-C711/661 Serial number '

©PRINTED IN JAPAN BG4-lO89-OO (K,E) (MC)
99/21'98/121110987654321

Page 2

Warning . . '

The making of products using lasers
(Except for some areas)

CLASS 1

LASER PRODUCT

The label is attached to the chassis/case and
says that the component uses laser beams that
have been classified as Class 1. It means that
the unit is using laser beams that are of a

weaker class There is no danger of hazardous

radiation outside the unit

Marquage des produits utilisant un
laser (Sauf pour certaines régions)

CLASS 1

LASER PRODUCT

L'étiquette est attachée au chassis/boitier de
l'appareil et indique que l'appareil utiliser des
rayons laser de classe l. Cela signifie que
lappareil utilise des rayons laser d'une classe
faible. II n'y a pas de danger de radiation
accidenteIIe hors de l'appareil.

La marca del producto Iaser

CLASS 1

LASER PRODUCT

Esta etiqueta esta colocada al chasis/a la caja e
indica que el componente funciona con rayos
laser de classel.

Esto significa que el aparato utiliza rayos laser
considerados como de clase debie. No existe
el peligro de que este aparato emita al exterior
una radiacicm peligrosa.

A marca dos produtos usando laser
(exceto para algumas areas}

CLASS 1

LASER PRODUCT

A etiqueta é presa no chassis/estojo e indica
que o componente utiliza raios laser,
classificados como sendo de Classe 1i Isto
significa que o aparelho esta usando raios laser
que sac de uma classe mais fraca. Nao ha
perigo de radiacao maléfica fora do aparelho.

2

ACAUTION

Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure

In compliance with Federal Regulations,
following are reproductions of labels on, or
inside the product relating to laser product
safety.

KENWOOD CORPORATION
2967-3, |SH|KAWA~CHO.
HACHIOJI-SHI

TOKYO, JAPAN

KENWOOD CORR CERTIFIES THIS EQUIPMENT
CONFORMS TO DHHS REGULATIONS No.21 CFR
1040. 10, CHAPTER I, SUBCHAPTER J.

Location : Rear Panel

FCC WARNING

This equipment may generate or use radio
frequency energy. Changes or modifications to
this equipment may cause harmful interference
unless the modifications are expressly approved
in the instruction manual. The user could lose
the authority to operate this equipment if an
unauthorized change or modification is made.

This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment may
cause harmful interference to radio .
communications, if it is not installed and used in
accordance with the instructions. However,
there is no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the
equipment and receiver. .

- Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.

- Consult the dealer or an experienced radio/TV i .
technician for help.

.-

This Class B digital apparatus meets all

requrrements of the Canadian'interference-
Causing Equipment Regulations. . '

REMAROUE - ,

Cet appareil numérique de la classe B respe'cte
toutes les exigences du Reglement sur le
materiel brouilleur du Canada. .

i
I
l
I