Kenwood KAF 3010 R Service Manual

Page 1

KM*1010(K)1P9814.253:57PM y[W 2 \
K7

WET-18187581 0R KENWOOD

SERVICE MANUAL

© 1998-3/851-5415-00 (K/K) 1948

Power lens Badge Power knob From panel Function lens Volume knob Direct lens Front frame
(819-1596-08) (843-0302-04) (K29-) (A60-1492-08) (819-1592-08) (K29-7381-08) (B19-1593-08) (A22-)

KENWQQQ:

vomME comm

k,

(Q C 3
Push SW Phone jack (D65) Speaker knob Control knob Selector knob Loudness lens Remocon window
(868-0105-08) (E11-0263-08) (K29-7376-08) (K29-7383-08) (K29-7379-08) (319-1594-08) (B11.0371.08)
Phono jack (2P) Slide switch System jack (D35) AC power cord bushing AC power cord
(E11-0188-05) (862-0069-08) (E11-0333-08) (J42-0200-08) (E30-)

©©©© T
@@©@©@

Matellic cabinet Phono jack (4P)x3 Screw terminal board AC outlet Slide switch
(A01 -3630-08) (E63-0186-08) (E70-0104-08) (E03-) (362-)

Illustration is KAF-3010R.
* Refer to parts list on page 18.

Caution : No connection of ground line if disassemble the unit.
Please connect the ground line on rear panel, PCBs, Chassis and some others.

Page 2

KAFrlomIK) 19 98.4.253:57PM y [w 3 if

KAF-1010/301 OR

CONTENTS / ACCESSORIES

Contents

CONTENTS/ACCESSORES. SCHEMAnCIMAGRAM.
CONTROLS ................................ EXPLODED\HEW ..........
chwTDESCWPflON. PARTSLST .........
ADJUSTMENT .. SPECIFICATIONS
PCBOARD .......

Accessories

Remote control unit (ll Batteries lRB/SUM-3l (2| AC plug adaptor ll)
(A074 232-08) (KAF-3010R only) (E03-Oi15-05l
(KAF-3010R only) Use to adaptthe plug on

the power cord to the

"4: Shape of the Wall outlet.
I (Accessoty only for

l ' regions where use is

necessary.)

SIS S

Caution

Operation m r959! Set the POWER to OFF then, while holding down the REMOTE
The microcomputer may (all into malfunction (impossibility to POWER key, set the MAIN POWER key to ON.

operate, erroneous display, etc.) when the power cord is un-
plugged while power is ON or due to an external factor. In this
case, execute the following procedure to reset the microcom- 'Please note that resettIng the mIcrocomputer clears the contents
puter and return it to normal condition. stored In It and returns It to the condItIon when It left the factory.