Kenwood DPC 641 Owners Manual

Page 1

PORTABLE COMPACT DISC PLAYER

DPC-741
UPC-641
DPC-542
DPC-541

INSTRUCTION MANUAL

KENWOOD CORPORATION

Note:
< This instruction manual is for common use Wllh the four models above.

Note for use In automobiles:

If you usethe unit in yourcar, install it in a place notsubject to direct
sunlight. Also do not leave that unit in carwhen not in use, forthis
will cause damage to the unit such as deformation by direct
sunlight.

[flfigfi

DIGITAL AUDIO

560140640 ® [E (K)

94/12

Page 2

Rudthkpngo carefully to
man ,,,,Lgae!o.,ooar' Lotion ,,

f are; ,pjymgépower

For the U.S.A. and Canada

Important!

Units shipped to the USA and Canada are designed for operation
on 120 volts AC only.

CAUTION: TO PREVENT ELECTRICSHOCK DONOT USE
THE AC PLUG WITH AN EXTENSION CORD. RECEFTACLE OR .
OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED

TO PREVENT BLADE EXPOSURE. ,

For the U.S.A.
FCC WARNING:

This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause
harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose
the authority to operate this equipment if an unauthorized change or modification is made.

NOTE:

This equipment has been tested and found to comply with the limits for :3 CLASS B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment may cause harmful interference to radio communications, if it is not installed
and used in accordance with the instructions. However. there is no guarantee that interference will not occur in a
particular Installation. If this equipment does cause harmful interference to radio or television reception: which can
be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one
or more of the following measures: ,

- Reorient or relocate the receiving antenna.

- Increase the separation between, the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected,
- Consult the dealer or an experienced radio/TV technician for help.

mesaMmas_

WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.

WARNING NOTICE:

The marking of products using lasers .
RIGHT TO MAKE COPIES OF TAPES OR DISCS WITH-
OUT THE PERMISSION OF THE COPYRIGHT OWNERS.
cussr ANYONE WISHING TO COPY COMM ERCIALLY AVAIL-
UISEJI PRODUCT ABLE TAPES OR DISCS SHOULD CONTACT THE ME-
This label is attached to the bottom panel and says that the ITEB OR THE PERFORMING RIGHTS SOCIETY UM-
oomponent uses laser beams that have been classified as Class I. '
It means that the unit is utilizing laser beams that are of a weaker

(Except for some areas). IN MOST CASES IT IS AN INFRINGEMENT OF COPY-
CHANICAL COPYRIGHT PROTECTION SOCIETY LIM-
class. There is no danger of hazardous radiation outside the unit.

Page 5

The standard accessories vary depending on the model of the unit.
The accessories which are not equipped as standard are optionally available. For details, please
consult vour dealer.

DPC-741 DPC-641 DPC-542 V DPC-541

AC adaptor O O O O

Audio cord

Rechargeable battery

Card remote control
u n it

Headphone with remote
controller

Car cassette adaptor

Car battery adaptor

OOOOOOO
XOOXOOX
OXXOXOX

Carrying case

XXOOXXOX

O

*: The card remote control unit can be used only with the DPC-74l and DPC-641. O : Equipped
It cannot be used with the UPC-541 and DPC4542t

Battery case 0 x

>< : Not equipped

Page 11

Headphone connection f

W ©
M

Use headphones equipped with a stereo mini-
plug.

- Fit the disc by pushing a position near the centre hole until it
clicks.

0 Close securely by pushing the front left position ofthe top cover
until it clicks,

Page 17

mmvxa Rafi L132 ' '-

To check the programme con-
tents

® Enter the stop mode.

® Press the P.MODE key.

P.MODE

To clear the programme:

6) Enter the stop mode.

® Press either button.

Press once.

Track number Program med order

- Each press displays the next track number in the programmed

order.

. r.»

:w-w
1 an M