Kenwood DPC 341 Owners Manual

Page 1

PORTABLE COMPACT DISC PLAYER

DPC-441
DPC-341

INSTRUCTION MANUAL

KENWOOD CORPORATION

Note:
This instruction manual is for common use with the two models above.

Note for use In automobiles:

ifyou use the unit in yourcar, install it in a place not subjectto direct
sunlight. Also do not leave that unit in carwhen not in use, for this
will cause damage to the unit such as deformatlon by direct
sunlight.

flfiéfi

DIGITAL AUDIO

sea-1399.10 ® El (KP)

94/12

Page 2

i .

Mreaggb'mepowq 4%his:,f;::.:,"::aazztzzz."t

For the U.S.A. and Canada

Important!

Units shipped to the U.S.A. and Canada are designed for operation
on I 20 volts AC only.

CAUTION: TO PREVENT ELECTRICSHDCKDO NOTUSE
THE AC PLUG WITH AN EXTENSION cone. RECEPIACLE on
OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED
TO PREVENT BLADE EXPOSURE

For the U.S.A.
FCC WARNING:

This equipment may generate or use radio frequency energy. Cha nges or modifications to this equipment may cause
harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose
the authority to operate this equipment if an unauthorized change or modification is made.

NOTE:

This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
resrdential installation. This equipment may cause harmful interference to radio communications, if it is not installed
and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

For CANADA
DOC REGULATION

"This digital apparatus does not exceed the CLASS B limits for radio noise emissions from digital apparatus as set
out in the radio interference regulations of the Canadian Department of Communications."

WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.

WARNING NOTICE:

IN MOST CASES IT Is AN INFRINGEMENT 0F COPY-
lExcept for some areas). RIGHT TO MAKE COPIES OF TAPES OR DISCS WITH-
- OUTTHE PERMISSION OFTHE COPYRIGHT OWNERS.
' CLASSI ANYONE WISHING TO COPY COMMERCIALLY AVAIL-
LASEBPHDDUCT ABLE TAPES 0H DISCS SHOULD CONTACT THE ME-
CHANICAL COPYRIGHT PROTECTION SOCIETY LIM-
, . ITED OR THE PERFORMING RIGHTS SOCIETY LIM-
This label is attached to the bottom panel and s that the ITED
component uses laserbeams that have been classifia as Class 1.
It means that the unit is utilizing laser beams that are of a weaker
class. There is no danger of hazardous radiation outside the unit.

The marking of products using lasers