Kenwood CD 206 Owners Manual

Page 1

KENWOOD

CD PLAYER

CD/DPF-R SERIES

CD-206 DPF-R6010
CD-204 DPF-R401O
CD-203 DPF-R3010

INSTRUCTION MANUAL

KENWOOD CORPORATION

This instruction manual is used for six models. Model availability and features
(functions) may differ depending on the country and sales area.

DTS disclaimer clause

When Playing DTS-encoded CDs, excessive noise will be exhibited from the analog
stereo outputs. The consumer should take proper precautions when the analog stereo
outputs of the CD player is connected to an amplification system. To enjoy DTS
Digital Surround playback. an external 5.1 channel DTS Digital Surround decoder
system must be connected to the digital output (SIPDIF, ASE/EBU, or TosLink) of the
CD player.

@EEAIE

DIGITAL AUDIO

Beo-ase4-00@( K,P,Y, M ,X ,T) _3
99/12111098765432198/121110987654321

Page 2

Units are designed for operation as follows.

USA. and Canada
Australia

AC 72 VONIV U.K. and Europe
AC 240 V UNIV China .....

Other countries

..... AC 230 V only
A6220 V only
AC 110- 120 /220-240 szitchable

*AC voltage selection AC voltage selector switch
The AC voltage selector swrtch on the rear panel IS set to the voltage E] The illustration shows
that prevails in the area to which the unit rs shipped Before connecting ACHD 22w mu l-Aczzurzwy m the CD-ZOG/DPF-RSO10.
the power cord to yourAC outlet, make sure that the setting position

of this swrtch matches your line voltage If not, ll must be set to your
voltage In accordance With the following leeCIIOTl

Note
Our warranty does not cover damage caused by excessive line voltage
due to improper setting of the AC voltage selector swrtch,

Move swrtch lever to match your III'IE voltage
With a small screwdriver or other pomted tool

For the United Kingdom
Factory fitted moulded mains plug

1 The mains plug contalns a fuse, For replacement, use only a I37Arnp ASTA-approved IBSTEGZ) fuse.

2, The fuse cover must be refitted when TepIaCIng the fuse in the moulded plug

3 Do not cut olf the mains plug from this equipment lithe plug fined Is not suitable lor the power points in your home or the cable rs [00 short to
reach a power point, then obtain an appropriate safety approved extension lead or adapter, or consult your dealer

ll nonetheless the mains plug IS cut off, remove the fuse and dispose of the plug Immediately, to avord a posSIDIe shock hazard by inadvertent
CDTTTIBCIIOII to the mains supply,

IMPORTANT

The wrres in the malns lead are coloured In accordance with the foIIowrng code:
Blue : Neutral
Brown : Live

Do not connect those leads to the earth terminal of a three-pin plug.

Safe recautions sec n carefully to ensure safe opera! n

WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAINOR MOISTURE.

CAUTION

RISK OF ELEcmIc sNocK
no Not OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EOUILATERAL TRIANGLE, IS INTENDED TO ALERT
THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE WITHIN THE PRODUCTS ENCLOSURE
THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS

THE EXCLAMATION POINT WITHIN AN EOUILATERALTRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE
OF IMPORTANTOPERATING AND MAINTENANCE (SERVICINGI INSTRUCTIONS IN THE LITERATUREACCOMPANYING
THE APPLlANCE

The marking of products using lasers
REDUIBEMENTBYNEDERLAND GAZETTE (Except " some 33)

CLASS 1
LASER PRODUCT
The marking is located on the rear panel and says that the compo
nent uses laserbeams that have been classified as Class 1 , It means

thatthe unit is utilizmg laser beams that are 01a weaker class There
is no danger of hazardous radiation outsrde the unit. 4

Batteries are supplied with this product. When
they empty, you should not throw away, Instead,
hand them in as small chemical waste,

Page 19

:m1g/HADTD/R3010En}
;

the common parts
,ng/DPFflSMO.

,ed on this page
I

- be repeated.
displayed, n0

< TM. a. ,

CDvEDE/ZOd/EDS/DPFRSD! U/FMDID/RSEMU [En]

Tu repeat one of the discs (CD-204/203/DPF-fl4010/33010 only)

OPress so that the "PGM" indicator

lights.
mans
-
QSeIect the disc.
ms: 1 DISC 2 ms: :1 ms: 4 ms: 5
E ' =- ,5 I: [:1 :1 E i:
6 Press the P.MODE key,
Pisa-- : ML
-_

Shes
OPress the REPEAT key,

E a? fifiQk}
6 Start playback
EELS

ii

PGM indicator ugh: up

[g
®®®®®

REPEAT indicator "gm up

To repeat the entire dist:

This allaws repeated playback of a" the tracks on the disc
loaded in the disc tray,

OPress so that the PGM indicator
goes off.

p MDDE

m 1::
fi-
BPress the REPEAT key
mm

y63)

For the CD-ZOS/DPF-RGOHJ

The current status is displayed when the key
is pressed once

When it is pressed while the status is disr
played, the repeat ON status can be set to
OFF (or vice versa)

0 Start playback,
pm (

E'Eg?

LL_l

CD-ZOB/DPF-RGM 0

CD-204/203/DPF-R401 0/R3010
PGM indicator goes 0H

CD-ZOG/DPF-RGM 0

CD-204/203/DPF-R4010/R3010
REPEAT Indicator tht up

E _ m,

@eéeeifl/

To cancel repeated playback

Press the REPEAT key.

agar

Lޤ

For the CDZOG/DPF-RSOW
Press the REPEAT key once againt
(REPEAT ON -O OFF)

afi

CD-ZOG/DPF~R601 0

CD-204/203/DPF-R4010/R3010
REPEAT indicator goes off,

Page 22

CD2o5/204/203/DPFR501o/RzimD/Ramo [Eni

To check the edited contents

CD-ZOG/DPF-R6010

CD-ZOS/DPF-REG 10

oWhen the CHECK key is pressed, track numbers and remaining time in
the file A are displayed first, then those in the tile B.

CD-204/203/DPF-R4010/R3010
CD»204/203/DPF~H4010IR3010 P.c, indicator light up

a: r

Furl-um @ a
W HF/LE

{/53

During normal EDIT:
IWhen the CHECK key is pressed, the track Nos. of edited songs will
automatically be displayed in the order they are edited.

During MULTI EDIT:
a Every time the CHECK key is pressed, the track Nos are displayed in
the edited order,

Playing or recording the edited contents

When recording the edited content onto a tape, it is recommended
to use the synchro recording or CCRS recording function at
KENWOOD cassette decks.

. > /
§;\\ - Do not adjust the output ievei from this Unit particularly during record

mg.
oFor details, see the instruction manual of the cassette deck.

li

content. The playback pauses at the beginning of the track

Press the NH key to start playback according to the edited
@ edlted for tape svde B. Presthe V/Il key again to continue

playback
To clear the edited contents 5
During Normal EDIT:
Press any one of these keys, 1
i
Home
E-nr
Main unit Remote control unit /
(CDrZOG/DFF-Rfioi 0 oniy) i
i
ELEM CLEAR 2
a
L-'J (MK i
\A kA
Le 3%
Do this operation in the stop mode. cThe edited data is cleared entirely,
During MULTI EDIT:
=-. I: n MDDE
Fl, a: E§>

last track on side A or Slde B may be cut short.

i. While you can edit with a different time setting to that of the tape you are using, part of the tape may be left With nothing recorded on it, or the
@Q 2. The EDIT function may not operate properly for discs having only one track or having tracks of long duration such as ciasSicai music,