Focal SM 9 User Manual

Page 2

SM9 - PROFESSIONAL ANALOG MONITORING SYSTEM
User Manual 3

An sample of this equipment has been tested and found to comply with the following European directives and
international standards:

Electromagnetic compatibility
EN 55T03
EN 6T 000

Electrical safety
EN 60065

Important safety information

Please read caretully tne tollOWing instructions and satety intormation. Recd al warnings and tolow all instructions

' Do not remove the back panel. There are no user serViceable pans inside; please rete' to qualitied service personnel.
Tnis equipment must be earthed.

Protect the power cord trom being Walked on or pinched part cularly at plugs, convenience receptacles, and the point wherethey
eXll trom the apparatus.

' Only use attachments/accessories specitied by the manulacturer.

' SerVicing is required when the uni' has been damaged in any way, such as power cord or plug is damaged, liquid has been
spilled or obiects have tallea into the unit, rhe Jl'tll has been exposed to rain or moisture, does not operate normally, or has been
dropped

' Do not place naked tlame sources such as lighted candles, on the apparatus.

Use the apparatus only in moderate climates (not in tropical climates).

' Do not expose the apparatus to dipping or splashing.

.

' Do not place obiects tilled With liquids, such as vases, on the apparatus.

CAUTION!

RISK OF ELECTRIC SHOCK

DO NOT OPEN

DO NOT EXPOSE TO RAIN OR MOISTURE

The 3M9 use a tweeter equipped With a Beryllium dome, alloWing a frequency range extending beyond 40kHz.
ln its solid torm, Beryllium is harmless. However, dueto its nature, certain special precautions should be observed to avaid exposure
to unnecessary risk:

' Under no circumstances shouldthe Beryllium dome be subiected to any torm ot abrasive action To ensure no accidental damage
to the tweeter dome it is adVised to caretully replace the protection covers while no' in Jse.

. ln the unlikey case at damage to tne dome, ot any torm, a Wide plOCC ot adhesive tape should be immediately used to seal the
whole tront surtace ot the tweeter. The protective cover should then be replaced and also taped securely in place. You should
then intorm the dealertrom whom you purchased the producr sothatthetweeter can be removed by a protessional and returned
to the product distributor tor replacement.

ltthe dome is broken in any way giving rise to loose particles ot Beryllium, these should be caretully collected With the use 0 an
adhesive tape a'id sealed in a lerTOp bag to be returned With the tweeter.

Forturther intermation, please contact FocalrJMlab directly: beryllium@focal.com