Fisher E 490 label Brochure

Page 1

CHASSIS LAYOL mu

Amauuswms Tuner and Cncilro'

.

EMBA ~A
ABOVE

O
ECC33
12AX7
0
mm
m m A Q
'- {or YoéHSb

Erw E K90
ones

6AU6

m m

DEOOE

ECCII (can

ECCBS
I 2AX7
1

CAUTION:

SERVICE SHOULD BE
PERFORMED BY QUALIFIED
PERSONNEL ONLY

\IAT I1AX7
momentum tmwmt , m
ouww ANSlSVORS N m oumn YEANSISVDIS NY
nlomisrr
mmm
mole commas mam swag, pis-
mmm KM. m mm mm. m. A Eccaa
910:er SPEAKER CABLES, omzlwlss FUSES V201 12AX7
w. now 5:; HOOK m ssnvlcz News
«was W Emu
man/onus 6Hus
mm Fuses A A
WIVH 1A ON vzoa vzoz
ms rm \ ,
Y NNEI V
now m.» .m onlvsn

n Pl

l

L]

l SWlKHED
Dunn

1 mm
M, m. Wm
5m. m.
.m [Err

WSJ W571
mom EerttNAL spams lm
mm c. c izr :

cum-on, inEltNAl 5mm: MUSY HAVE m.
mus pmmcs EQUAL 1o on mum mm roux
ems. on ruszs wiu new we atom :incurr

THE FISHER.

105-120 VOLTS MODEL 5-490
60 CYCLES

192 WATTS SERIAL
225 VA NUMBER

This apparatus uses Inventions of United States patents, licensed by F1
Corporation of America. Patent numbers will be lurnished on rear

FISHER RADIO CORPORATION ' NEW YOF

ruszs roa
llGNY :HANNEl tzr
ro
SIEAKEI
SEIK on

N 1163-100

BULB REPLACEMENT

NOTE: Before replacing bulbs, disconnect power plug
from wall as a precaution.

DIAL LAMPS

1. Remove all control knobs from shafts by gently pulling them
away from control panel.

2. Remove the two screws located on upper right side of par-
tition separating turntable compartment from control section.

3. Slide entire control panel (plate and wood panel to which it
is fastened) to the right and upwards. Panel can be lifted off,
to expose chassis.

4. The lamps, tubular in shape. are held in spring clips at
either end of dial glass. and can be removed by lifting gently.

5. Install new lamp. making sure that white, painted side faces
away from dial'glass, Press lamp down until it snaps into place.

6. Replace front panel by reversing steps (1) through (3) above.

Replacement dial lamps can be ordered from the Parts Dept, of

Fisher Radio Corporation.
Long Island City 1, New York,
as part No. |50441~3

STEREO BEACON LAMP

1. The lamp is housed in a white cylinder on underside of
chassis front panel. Follow leads which protrude from rear of
cylinder to terminal strip on chassis.

2. Slide Clips which terminate leads off terminal strip contacts.

3. Remove white flexible band which secures bulb in cylinder.
Remove bulb from cylinder.

4. Place new bulb in cylinder, secure with band removed in
previous step, and slip clips over terminal strip contacts.

Iacement dial lamps can be ordered from the Parts Dept. of
Fisher Radio Corporation,
Long island City 1, New York
as part No. I50461-8.