Cello encore 150 owners manual

Page 1

Page 2

GENERAL PRODUCT SAFETY For your safety and the proper operation of this product, please read both this document and the owner's manual before continuing to unpack or install this product. 1 ) This product is designed for indoor commercial or residential use. Never use this product outdoors, in high humidity or in the presence of combustible materials. This product should be placed on a strong stable surface that provides both lateral stability and proper load bearing strength. This is especially necessary for amplifier stacks and tall, heavy loudspeakers which may fall and cause injury. 3) This product requires proper grounding for safety. This is normally provided by a grounded outlet. Also observe power requirements in owner's manual. The chassis of this product will be at ground potential whenever the product is plugged into a properly grounded AC mains outlet. If there is any doubt about the integrity of the AC mains outlets, have the outlets inspected and/or serviced by qualified personnel. It is imperative to use this product only with other products that are properly designed for electrical safety. Note: Chassis grounding does not apply to passive loudspeakers. 4) Keep this product out of the reach of children and pets and keep them away from the area during installation and setup. 5) Never drop objects or liquids into the vents of this unit. Do not operate this product if it is damaged by a fall or impact, or has exhibited any signs of malfunction such as repeatedly blowing fuses, sparks, smoke, repeated breaker trips or severe signal distortion. If any such events should occur, unplug the unit from the AC mains. Have the unit serviced by qualified service personnel before re-using. 6) Be careful to avoid physical injury when moving large and/or heavy products. 7) Remove all jewelry before installing product. This is especially true of loose fitting chains and bracelets. Beside possibly scratching the product, these may enter vents and/or terminals and cause electrical shock. 8) All electrical inter-connections (input signal, cable antenna, speaker, DC etc) should be made before connecting the product to AC mains power. The reverse is true when disconnecting the product. 9) Hazardous voltages may remain present inside some products for a considerable amount of time after turn-off or unpluging from AC mains power. This is particularly true of power amplifiers and their associated supplies. Observe all label warnings. 1