Aiwa ADC M105 Owners Manual

Page 1

-:l:|:|:| if -:I:|:|:|
\ /

K \
1

a I ma [flfigfi

DIGITAL AUDIO

OPERATING INSTRUCTIONS ADC_ M 105

MANUAL DE INSTRUCCIONES YU

MODE DEMPLOI COMPACT DISC CHANGER
CAMBIADOR DE DISCOS COMPACTOS

OWNERS RECORD

For your convenience, record the model number
and serial number (you will find them on the rear of
yourset) in the space provided below. Please refer
to them when you contact your AIWA dealer in
case of difficully.

Model No. ADC-M105
Serial No- :

SZ-KM3-922-01
001110ATM-OX

DOADCM105.YU.CUV 3 01.1.31 352 PM

Page 2

l e m

Welcome

Thank you for your purchasing this AIWA product. To optimize the performance of this unit, please read

through this manual carefully.

I TABLE OF CONTENTS

FEATURES
PRECAUTIONS
UNPACKING
INSTALLATIONS .
CONNECTIONS
HOW TO USE ..
SPECIFICATIONS

ocooo-bwma

I FEATURES

- Tracksfrom10 CDs stored in the disc magazine
can be selected and played.

- Horizontal, vertical, slanted or suspended
installation can be made.

- Through the window at the top of the unit, you
can see a disc spinning as it plays.

- Since it is smaller in size, you will find it easier
to install the unit.

In addition to ordinary CDs, CD-FIs or CD-RWs
can be read by this unit. However, NEVEFI use
a CD-R or CD-RW that contains no data or data
in the wrong format, such as MP3 or other
computer files.

When you insert a CD-R/CD-FIW, it may take
longer to start playing.

| ENGLISH

01ADCMIDS.YU.E 2

NOTE

This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation.

This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is noguarantee
that interference will not occur in a particular
installation. If this equipmentdoes cause harmful
interferenceto radio ortelevision reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:

- Fteorient or relocate the receiving antenna.

-|ncrease the separation between the
equipment and receiver.

-Connect the equipment into an outlet on
circuitdifferentfrom thatto which the receiver
is connected.

- Consult the dealer or an experienced radio/
TV technician for help.

CAUTION
Modifications oradiustmentstothis product, which
are not expressly approved by the manufacturer,
may void the users right or authority to operate
this product.

01,131,353 PM

Page 11

l-IZD 4e -)

I SPECIFICATIONS

Notes on the disc magazine Compact disc changer _ _ _ _
- Be sure to place a disc on the disc tray with the sysem Sigrid d'sc d'g'm' aw)
label side up. If a disc is not set properly, it may Frequency response 5 HZ V 20 kHz
cause damage to the unit. Wow and llutler Below measurable |lmi1
Signal to noise ratio 91 dB or more
Outputs Line output (for changer
connector only)
Operating temperature
710 C to 55 C
Dimensions 254 X 83 X 173 mm (w/h/d)
(10 x a 3/5 x 6 7/5 in.)
Weight 2.1 kg
(4.62 lbs.)
Power requirement 12 V DC car barlery
(negative ground)
D/A converter 1 bit DAC, 8 times over
sampling
. Sampling rate 44.1 kHz
0'53 aV Disc size 120 mm
Supplied accessories Disc magazine (1)
- Thedisctray may betaken oflfromthe magazine M°""9 k (1 59)
. . . Connecting cable (5 m)
If you pull the tray forCIbly. lfithe tray Is taken (16.4 ft.) (1)
out, put It back Into the magazme as Illustrated.
Be sure that both ends ofthe tray are aligned to Design and specifications are subject to change without
the grooves of the magazine correctly. "09-
Groove
- Disc
magazine
Disc tray
Groove
- Be sure all the trays are set in the magazine
when using the unit.
ENGLISH 1O

D1ADCM105.YU.E 11 @ 01.1.31, 353 PM