Acurus 200 five owners manual

Page 2

Congratulations on your purchase of the Acurus 200FIVE Home Theater
Power Amplifier. As the originator of the three channel amplifier. we have
created the 200FIVE to give you the benefit of separate two and three channel
amplifiers In a single chassis. Please read this brief owners manual. Upon
completion you will understand the set-up and operation of your 2OOFIVE.

i. Although all Acurus components
are burnt-in prior to delivery, if

has been our experience that the
amplifiers continue to Improve
during the first 250 hours of use.

2. Allow adequate ventilation on all
sides of the Acurus amplifiers. Never
place directly on carpeted floor.

3. NEVER attach or remove speaker
cables or Input cables with the
amplifier on.

4. Remove power cord from wall
outlet when changing fuses.

5. Be very careful with the placement
of all your systems wiring. Many times
placement of wiring will alter the
amount of background noise or hum
that is audible.

CONNECTIONS

INPUT-Connect your preamplifier

or processors line level outputs to
the appropriate input lacks an the
rear panel. The 200FIVE is designed
with five Independent channels.

Be certain to connect the right front
and left front outputs to the specific
inputs located on the rear panel. This
will afford you the optimum stereo
as well as home theater operation.

OUTPUT-Attach the amplifier speaker
outputs to the appropriate input
connectors on your loudspeakers.
Caution should be taken that the +
(red) and - (black) speaker cable
connectors are not touching each
other, both behind the amplifier and
behind the loudspeakers.

Ac POWER-Connect the amplifier
directly to your A.C. wall outlet. The
Acurus 200FIVE ls capable of delivering
tremendous power to your speakers.
but not if its ability to receive AC
current is restricted in any way. We
suggest you do not use an extension
cord however. If you must use an
extension cord 14 gauge wiring is a
minimum.

SPECIFICATIONS

Rated Power

200 watts per channel continuous.
each channel driven into 8 ohms
20 Hz to 20,000 Hz at no more than
0.06% THE)

250 watts per channel continuous,
each channel driven Into 4 ohms
20 Hz to 20,000 Hz

input Impedance
20K ohms

input Sensitivity
1.8 volts for full output

Signal to Noise Ratio:
iiOdB A Weighted

Dimensions:
17" x 6 3/4 x 14

Weight:
47 lbs.

Owner's
nformatlon